Magnetic Rubber-Coated Cable Tie Mounts 4-Pack

Clean up your cabling without committing to permanent installs.

These magnetic cable tie mounts let you secure wiring, hoses, and leads wherever you need them, then move or remove them just as easily. Built for 4WDs, campers, caravans, and off-grid setups, they give you a simple way to keep cables tidy on metal surfaces without drilling or adhesives.

Each mount uses a rubber-coated neodymium magnet to hold firm while protecting paint and surfaces. The built-in cable tie slot makes routing cables quick and straightforward, whether you’re running solar wiring, Starlink cables, or workshop leads.

It’s a practical solution when you want clean cable management without making permanent changes to your setup. Strong, reusable, and ready to handle real-world touring conditions.

• No drilling required, keeps your setup clean and reversible
• Strong magnetic hold without damaging paint or surfaces
• Rubber coating protects against scratches and wear
• Quick cable tie mounting for simple cable management
• Easily repositionable for changing setups or layouts
• Works across 4WDs, campers, caravans, and boats
• Ideal for routing Starlink, solar, and accessory wiring
• Helps keep cables off the ground and out of the way
• Built for vibration, heat, and dusty touring conditions
• Includes cable ties so you can install straight away

Perfect for:

• Temporary Starlink, solar, or accessory wiring on vehicle roofs
• Routing cables along roof racks, trays, canopies, and metal panels
• Keeping wiring off the ground
• Managing power leads, air hoses, and sensor cables in workshops
• Campers, caravans, boats, service vehicles, and off-grid setups

Specifications:

• Magnetic type: Neodymium
• Coating: Rubber-coated for surface protection
• Installation: Tool-free, no drilling or adhesives
• Pack size: 4 mounts per pack
• Included: Cable ties
  

Size Options:

• 22 mm – compact, lightweight cable routing
• 31 mm – balanced strength for general use
• 43 mm – highest holding power for heavier cables

These mounts are designed for quick, tool-free installation and repositioning.

Installation:

1. Clean the mounting surface to remove dust, dirt, or grease
2. Place the magnetic base firmly onto a suitable metal surface
3. Route cable, hose, or wiring through the built-in channel
4. Secure using the included cable tie
5. Trim excess cable tie length if required
6. Reposition by lifting and relocating as needed

• Suitable for metal surfaces only
• Works best on flat or mildly curved steel surfaces
• Not suitable for aluminium, fibreglass, plastic, or non-magnetic surfaces
• Mount strength depends on surface contact and cleanliness
• Clean mounting surface before use for best hold
• Not intended as a primary load-bearing anchor point
• Strong vibration or corrugations may reduce hold over time
• Repositionable without damage to surfaces
• Avoid high-heat areas that may reduce magnetic strength
• Ensure cables are not under tension that could pull the mount free
• Ideal for temporary or semi-permanent cable routing setups

• 4 x Magnetic rubber-coated cable tie mounts (selected size: 22 mm, 31 mm, or 43 mm)
• Cable ties included for each mount
• Pre-assembled units ready for use out of the box